[creativecontrol]

[DEFINING SELECTIONS]

(1) Use the Mark In and Mark Out switches above the numpad section on the Automation Module. Press Mark In (latches) then use the Wheel to define the In point. Press Mark Out (latches) then use the Wheel to adjust the Out point. Use the Trim switch (left of the wheel) then use the Wheel to move the existing selection or insertion point. To clear the selection and turn it into an insertion point, press the Down Arrow above the numpad section on the Automation Module. Use Shift (Fader Module) + Down Arrow to Restore the Last Selection.

(2) Use the Next and Previous switches from the Transport controls (above the FF and REW switches) to move and select the next or previous clips. Hold Shift (Fader Module) while using the Next or Previous switches to define a selection over a range of clips.

(3) Access the Workflow Soft Keys page via Extras from the right Automation Module Soft Keys. With a selection defined, use Move Back Sel or Move Forward Sel to move the selection forward or backward on the timeline by the selection amount. Use Move Down and Move Up to move the selection to tracks below or above the currently selected track. While holding Control (Fader Module) functions are modified to Halve or Double the existing selection amount. Additionally, the selection can be extended into tracks below or above the existing track using Extend Down or Extend Up.


Jeff