d8b not getting timecode

[rrood]

Hi. I've been mixing Pro Tools through a d8b just fine for some time but have recently lost the MTC timecode from PT. It may have been the clean install I did or it may have happened when I went to 5.1. Is anybody running this configuration or something similar?
PT Mix+
V5.1
d8b OS3
Studio 64XTC
Mac OS 9.0.4


rrood

[woodywho]

Hey are you running oms or omf? If you are make sure the D8B is in your equipment list! Make sure in midi routing you have the D8B talk to your studio 4 or unicorn or motu ...you get the picture. With protools open go to status screen under display and check off time code to D8B! Hope this helps!!

------------------
"Have you seen my 2 inch reel??"

[DigiTechSupt]

Originally posted by rrood:
...but have recently lost the MTC timecode from PT.

-There is a bug in PT 5.1 which resets the MTC to Port Selection (Session Setup Window) to "None" every time you close a session. Enable the D8B in the Session Setup Window whenever you open a session.

-This will be fixed in PT 5.1.1

Brent

[rrood]

I was wondering about the port selection resetting every time! But that's not it... It sure looks to me like everything's set up correctly. I might try going back to 5.0.1 just to see if I can get that to work.
Woody- what is the "status screen"??

rrood