Turning off fader motors

[Fullsound Recording]

Is there a way to turn off fader motors when running automation?

C/24 HD
xp sp3

[Fullsound Recording]

anyone

[Halfmoon]

Yes. C24 guide (8.0 edition), page 46 or something: It's an on-board Pref accessed via Soft Keys

Soft Keys Switch
The Soft Keys switch provides access to C|24 preferences, Pro Tools actions and Automation preferences directly from the LCD displays.
To set a preference or action from the Soft Keys:
1 Press the Soft Keys switch.
2 Press the encoder switch that corresponds to
the displayed item to cycle the preference setting
or perform the command.
3 Press the Soft Keys switch to exit.
The following console preferences, actions and
and automation preferences are available:

Console Preferences
Faders (Faders On/Off) Temporarily turns off C|24 faders to prevent fader movement when monitoring a mix.

***
I hope this helps.

[PierrevC]

On the control 24 it's much easier to switch to master faders or trim mode if the noise of the faders is bugging you. Not shure about the c24 though.