PT HD9 Bounce to QuickTime Movie

[hangart]

Hi all,

I have a problem with bouncing to mov.
After bounce, seeing the mov, the picture and the sound are not in sync.

The source mov was 29.97 fps, so I set the Time Code Rate to 29.97 too, so its white now.
What can I do, to make shure, it will be in sync after Bounce to QuickTime Movie?

Thanks for you help!
Tom

[quadraphonics]

There are a few possible issues:

If the sound is drifting, you might have selected the incorrect sample rate when bouncing (i.e. 44.1k instead of 48k).

If you have a lot of delay compensation going on and bounced out the main hardware outputs, the system might have induced that delay into your bounce.

Randall

Originally Posted by hangart

Hi all,

I have a problem with bouncing to mov.
After bounce, seeing the mov, the picture and the sound are not in sync.

The source mov was 29.97 fps, so I set the Time Code Rate to 29.97 too, so its white now.
What can I do, to make shure, it will be in sync after Bounce to QuickTime Movie?

Thanks for you help!
Tom