Strike- set content trouble

[WarrenG]

I had the same problem (along with Transfuser and Velvet) on a new system. Installed PT10.3.2 then the PTIEP and couldn't find the content, in spite of running the set content location program.
In the end I removed PT (leaving the settings) and reinstalled and this seemed to work. I may have had to re-run the set content location program again, but I can't remember that now.
Anyway, it's all working now!

[lwilliam]

Any update on this? I tried a search and only came up with this thread.

I just upgraded from PT9 to PT10 (10.3.2) and couldn't get Strike to recognize the content even after running the SetContentLocation app several times.

I tried re-installing Strike, re-installed the virtual instruments, and then upgraded 10.3.2 to 10.3.3. SetContentLocation app was re-installed with 10.3.3, but it still doesn't work with Strike (still can't find content). The SetContentLocation app is in the same folder as the .big files.

This is getting old, isn't it? All my 3rd party plugins seem to work, but Strike gets trashed by the upgrade?

[redefer]

I basically gave up; at least for now. I'll check back from time to time to see if a solution appears. Good luck all!

[redefer]

Well, I'm ready to start the good fight again. Has anyone had any luck with getting STRIKE to work properly?