nothings happening

[grandmastrmahoy]

I have a Digi 002R and I have a M-Audio Radium 49. I am trying to use the radium to control reason. and nothing is happening.

Any help, I am new to MIDI
I installed the drivers
The Radium is connected by USB

In My Audio Midi Setup I show the Digi 002, my Tone Lab, somthing else with a picture of a midi interface with [1x1], and somthing with a picture of a keyboard with a red question mark on it




Please Help

[cheekypaul]

are you using a mac or a pc? which version of the software are you using? we need more information.

if mac, check the reason preferences. on the midi tab click "scan for midi hardware" ... or similiar...
to control a specific knob on screen, ctrl click and select edit midi control.

why am i answering this, it's a digi duscussion?

also check out the excellent propellerheads site...

[Chief Technician]

In My Audio Midi Setup I show the Digi 002,

Good.

my Tone Lab,

Good.

somthing else with a picture of a midi interface with [1x1],

That would be your M-Audio Radium 49.

and somthing with a picture of a keyboard with a red question mark on it

That would be the Digidesign CoreAudio driver.

I can't remember specifics, but in one of the MIDI pages in Reason's preferences (Advanced MIDI?) there are four buses where you specify a device for each bus. For bus A, choose the 1x1. In the main Reason window, at the top where you can select which bus is being used for input, select bus A. Now load a module in your rack, and select it on channel 1 in the top device of the rack (where you selected bus A for input).