Driver Install Error After Upgrade to 7.3

[tikboy]

Hi, it's been a while since the last post.

I just upgraded from 6.4 to 7.3. Everything works fine except for an error notice every time I launch PT.

"ProTools detected a driver install error..."

During the installation, it also did a firmware update of the digi002 rack.

I am still exploring the new software. I have opened and tweaked old sessions and they're fine. I'm still to test recording on it. The error message warns about "slow recording".

- Any ideas about the driver error notice?
- Is it the digi002 rack's driver?
- Is there an updated driver...Where can i get it?

I will appreciate any help.

Thank you.

[tikboy]

[bump]

[tikboy]

[re-bump]

[DigiTechSupt]

You should start with the steps in the Win XP/ Pro Tools 6.x/7.x General Troubleshooting thread and post specific info on your system per the info on that thread if you're unable to resolve the problem.

You may want to look at the Help us help you thread as well.