Group Bussing Question

[kujo2all]

IF you had a bunch of GTR tracks for example, is there a way to send the group signal completely through a bus channel strip? I had 8 gtr tracks that I was sending to a compressor then an EQ, but when I tried to mute the faders on the original individual tracks, the group bus stopped sending out audio. So do I have to send most of the group signal through a bus while keeping some of the original audio track information (just at a lower level in the mix)? Thanks in advance.

[The Dougfather]

If the tracks are grouped then it's likely that mute, solo etc are group linked, you configure this when you setup the group. If you switch groups off when you mute/solo one track it won't mute them all.

You can also hold CTL while adjusting a group parameter and the other members of the group won't be affected.