Word Clock Question

[Chromefree]

Hi Guys,

I've an old Digidesign 96i i/o and am adding a Lynx Aurora 16 LT-HD as well as two Audient ASP 800 preamps.

I'm planning on using the 96i as master clock out to the Lynx.

Can I take the Lynx CLOCK OUT and split it with a "T" connector to feed the two mic pre amps?

If not, what would be my best solution without having to spring for a separate Master Clock?

Thank you kindly for your responses...

[mesaone]

Originally Posted by Chromefree

Can I take the Lynx CLOCK OUT and split it with a "T" connector to feed the two mic pre amps?

Yep. In your case the second device downstream from the T-bar needs 75 ohm termination. No problem there, ASP800 have switchable internal termination.

My advice: get 2 or three T-bars for every one you plan to use. I've had a few BNC adapters go out one me, one mid-session, and a backup or two is always good to have on hand..

[JFreak]

bear in mind that every passive split drops the signal level, so don't buy very long cables

[Chromefree]

Thank you Matthew!

[Chromefree]

Thanks J,

I plan on using two 3' BNC cables off the splitter to the two mic pres

[JFreak]

One meter should not hurt anyone. Talk about +10 meters and we'll see some other cable recommendation than regular RG58


Sent from my iPhone using Tapatalk