projectmix + m-powered at 96kHz?

[delpinator]

Hi

I´m tryng to make a session at 96 kHz and it´s impossible for me....
In new session, I can only select 44.1 kHz... I´ve tried to change the sample rate on prejectmix and it´s impossible...
Finaly, I sync through external spdif and a roland vs-2480 and all ok, BUT, when I tried to open this session at 96 kHz, appears:
"The current playback engine does not support a sample rate of 96 kHz"....the same occurs with 48 kHz...with internal sync its impossible select other rate than 44.1 kHz

¿What can I do??...I´m desesperated!!!!

Thanks and cheers

Carlos
Madrid, Spain

[temetrepo]

yes, you can record at 96KHz
i'm able to do it without a problem
i've had this message pop up every now and then, and when i check i also have the windows media player or any other audio app running also. Try to run PT alone when you're going to use it.

Hope this helps

[delpinator]

No...I can´t....

I always run protools m-powered....

please, what can I do?

thanks and cheers

[delpinator]

sorry...

I always run protools m-powered....alone

[delpinator]

sorry...

I always run protools m-powered....alone

[Marcus S.]

Ola Carlos,

This solution is weird but official

"The current playback engine does not support a sample rate of 48 KHz" error when trying to open a non-44.1 KHz session in Pro Tools M-Powered.
This will happen when Windows is using the MAudio device as the 'default' sound device.

SOLUTION:
Go to Start > Control Panel and choose "Sounds and Audio Devices"
Verify that the M-Audio device is NOT selected as the default device, or the device will be limited to 44.1 KHz.

http://www.digidesign.com/index.cfm?...0&itemid=22413

Ohh yeahhh do you need other audio card and setup as Default. Motherboards with audio onboard works fine as Audio Default + Protools.

Astalavista
Marcus - Brazil
www.purevolume.com/superbus

[Yosemite]

The solution Marcus proposed is most likely going to fix your problem. If it doesn't though, try disabling any onboard sound from the device manager. I don't use the same interface as you, but I use M-Powered on two machines and to create 96k sessions on one I do what Marcus does, on the other I have to disable the onboard sound when running PT M-Powered to get 96k.

Good luck!