Tethering ER11 & Triaxis presets

[LDO1966]

Hi all, newbie alert.

Been trawling for days to find a solution and no luck so far, sure others must have asked but cant find anything with the answer.

I have a triaxis through the FX loop of my 11R and would like to link together the presets of the two units. So if the preset gets changed on the 11R either in PT or on the front panel the right preset gets dialled up on the Triaxis.

I had hoped the PT sending midi to change the 11R preset would also change the triaxis preset if they are on the same channel, but no. I can set up a midi track in PT to do this, but no good if have more than one guitar part in my session.

Wondered how other managed it. I have an FCB1010 but that doesnt help as I am effectively trying to piggy back off the embedded rig settings ability in PT by tethering at least the triaxis preset, though sadly not any further parameter settings.

Thanks in advance.

Loz

[Deansy]

Set the midi Thru in the eleven Rack to "ON" and make sure that the Triax is the last in the chain. Now that midi thru is on, A copy of Whatever you send to Eleven via midi will be sent out from the Eleven MIDI out and the Midi out of Eleven should connect to Triaxis midi In.

[LDO1966]

Thank you Deansy, did that, unfortunately doesn't work.

I know both devices are currently listening on channel one since either the foot controller or PT midi track will alter both with sync'd presets. Loading the embedded rig/preset from the recorded track doesn't get through to the Triaxis, neither does changing the ER11 preset in the PT ER11 plug in. Guess none of these actions are using MIDI to communicate with the ER11.

Can anyone confirm?