|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
|||
|
|||
Bouncing with Soft Samplecell and ATTO
Greetings all.
I was trying to do a bounce today on an HD system with some audio tracks and some Soft Samplecell drums. Playback was fine, but when I tried to bouce to disk I was getting a lot of pops and clicks. I thought it was my Sync I/O so I took it offline, but no dice. Still had noises. Long story short: the problem was my ATTO burst rate setting. I had the transfer rate set correctly at 20(10) but the burst rate was set at 512. Taking this down to the recommended 32 (thanks Digi Tech Support) cleared up the problem completely. Just FYI for you folks with an HD and Softsamplecell.
__________________
Barry Young Young Creative |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Soft Samplecell 3.1 When? | J Fernandez | Pro Tools TDM Systems (Mac) | 3 | 04-20-2002 12:50 AM |
soft samplecell?'s | clay j. | Digidesign Hardware & Software | 3 | 01-14-2002 12:24 AM |
Soft SampleCell + ATTO Problem | Vinylizor | Pro Tools TDM Systems (Mac) | 19 | 01-02-2002 12:34 AM |
Soft SampleCell not compatible with SampleCell 2 | P BUCKLE | Digidesign Hardware & Software | 13 | 06-08-2001 11:01 AM |
Soft SampleCell not compatible with SampleCell 2 | P BUCKLE | Pro Tools TDM Systems (Mac) | 11 | 06-06-2001 10:24 AM |