"Could not complete bounce..."

[jonnn]

So I'm trying to bounce a new mix last night. It makes it all the way to the end of the song. It says 0:00 time remaining. Then I get this nice little message:

Could not complete the Bounce to disk command because Assertion in "\code\aztec_Lomax\AlturaPorts\NewFileLibs\Ff\Audi o\FF_AudioProperty.cpp",line 33

I tried just bouncing a 3 second clip to see if it would do it again and it worked just fine. So I tried the whole song again and got the error message again.

I started a new session and imported all the session data and tried again. Got the error message again.

Does this mean I have a corrupted session (again)? Or is there some other reason for this?

I would reeeeeeeeeeeeally appreciate any help I can get.

Thanks,

jonnn

P.S. Running PT 7.1 cswhateverismostrecent 002R
Windows XP Pro sp2
Music XPC M2 Laptop
1 gig ram

[rickthestick]

I've has similar problems when a fade goes longer than an audio track. I've also had plugs screw up a bounce.

Just a couple suggestions, good luck.

[jonnn]

I extended the bounce selection by one second and it worked.

Freakin' weird.


Anyway, thanks Rick.