|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
|
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
protools an icon platform M+ - cannot communicate stable
After a busy christmas I finally sat down to setup my icon platform M+ with my protools 2018.10.0 setup on my mac.
All pretty easy to setup, power, USB into mac, update the firmware to current 2.03 - use the platform M+imap app to update and connect. Follow the online quick start from icon https://s3.amazonaws.com/assets.icon...-Pro-Tools.pdf, setting the m+ mode to HUI inline with the 2.0 firmware changes all pretty straight forward. boot the m+ and protools, the faders slide once to "ready" position then I get a pro-tools error "Pro Tools is unable to communicate with the HUI, Power-cycle the HUI and check it's connections, Note, if HUI is not in use, update the Peripherals dialog to prevent further warnings" basically, I can't talk to your controller. tried a few different USB cables (not got a huge amount of the type 2 cables spare same result. Any one got their M+ working with 2.03 and pro-tools or seen this problem ? |
#2
|
|||
|
|||
Re: protools an icon platform M+ - cannot communicate stable
managed to get it to connect for a few seconds before the popup and move a fader, the D2 screen that's connected to it then gets a load of garbage on it and the faders are clicking very quietly and fast, almost as if it's getting loads of data and moving the faders 100 times a second and the click is the "setting" of the fader position.
|
#3
|
||||
|
||||
Re: protools an icon platform M+ - cannot communicate stable
Way out of my league here, just a thought. The controller is USB 2.0. Are you using a USB 2.0 port?
__________________
Take your projects to the next level with a non-union national read at reasonable rates Demos: brucehayward dot com SonoBus Source-Connect: brucehayward Options for Remote Direction |
#4
|
|||
|
|||
Re: protools an icon platform M+ - cannot communicate stable
controller is usb2 it's plugging into a mac with a usb 3 port only (no usb 2) but I did think of that and tried it with a usb2 hub plugged in, just for interest (as I had a similar problem with the ilok) no dice, but a great suggestion, so thank you.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Icon platform m+ | jchan | Pro Tools 2018 | 14 | 08-29-2022 12:15 PM |
HUI Issues with Icon Platform M+ and PT12 Mac | Mark Roberts | Pro Tools 12 | 7 | 11-18-2019 10:35 AM |
Waves Edition iCon Platform M | Alex TCH | Avid Pro Mixing General Discussion | 1 | 08-21-2018 01:55 AM |
HD not a stable platform? ADC issue + more! Help! | freedomof81 | Pro Tools TDM Systems (Mac) | 6 | 12-18-2009 10:28 AM |
Most Stable Platform for Digi002 | kojak | General Discussion | 4 | 02-20-2009 07:48 PM |