|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
|||
|
|||
AKG C3000/Digi-001 problems
Yooooo...... anyone using akg c3000 straight into digi's preamps? My setup is about 1 week old and I noticed a little bit of harshness or digital noise when recording vocals(24 bit files, Monster 100 XLR,pop filter, on R&B and Rap music). Anybody noticed this too???? I really wanted to get the Neumann TLM-103, but I've used the C3000 and Adats many times with no problems.
any suggestions??? Thanks
__________________
Docta'J Download free music at http://www.nukmusic.com nEVER uNDERESTIMATE kNOWLEDGE |
#2
|
|||
|
|||
Re: AKG C3000/Digi-001 problems
the analog ins 1 and 2 dont work. Period!!! at least it's my opinion. did you engage the pads? turn down the gain?
|
#3
|
|||
|
|||
Re: AKG C3000/Digi-001 problems
I thought this was all just me but it appears there's lots of people that cant record to in's 1 and 2.
|
#4
|
|||
|
|||
Re: AKG C3000/Digi-001 problems
Hello all. You're kidding, right? If not, there must be something wrong w/ your unit. I use my inputs(1&2) all the time w/ no problems... [img]images/icons/confused.gif[/img]
__________________
soundphaRm |
#5
|
|||
|
|||
Re: AKG C3000/Digi-001 problems
yes....... I've tried the pads on Digi and on the c3000 with no luck. and everthing is brand new digi, c3000, and the cable. today I even tried my old $50 Radio Shack mic(Shure) and cable with I 've used countless times for recording rough vocals in Cubas and Cakewalk with no distortion. I'll try the rear inputs to see with happens.
__________________
Docta'J Download free music at http://www.nukmusic.com nEVER uNDERESTIMATE kNOWLEDGE |
#6
|
|||
|
|||
Re: AKG C3000/Digi-001 problems
We've been using the 1/2 mic inputs for over a year with anything from a 57 to an AKC C-4000B, 414's, no problems. They are quite neutral preamps, and work fine for most applications.
If your XLR's are not working I suggest you contact Digidesign for a repair. You may have the well known crappy wave solder joint on the connectors. wiggle them around, fi the connection gets better/worse, then you need to touch up the solder points from connector to pcb. Not the easiest to get to, and once you are in there do all the connector pcb points, and you should have no problems. The 001 interface is well known for it's poor soldering on the connectors to pcb. There have been many posts regarding this, mostly to do with the rear connectors, but I suspect the front ones coule also be subject to this issue, afterall they are all done at once on the same machine. Hope this is helpful. |
#7
|
|||
|
|||
Re: AKG C3000/Digi-001 problems
Personally I think it's the C3000. I used the 1/2 inputs with a borrowed EV RE-20 with wonderful results, bought a C3000 when my friend was ungracious enough to want his mic back and had exactly the same problems nukmusic describes. I've since sold the C3000 and record with a Shure KSM 27, which is awfully sweet. Could there be some basic incompatibility here?
__________________
If you don't think too good, don't think too much. Something to think about. |
#8
|
|||
|
|||
Re: AKG C3000/Digi-001 problems
My mackie 24-8 just hits it too hard. I do think there's something wrong with it. I end up just using the 3 and 4 ins. I have the board set to +4
|
#9
|
|||
|
|||
Re: AKG C3000/Digi-001 problems
I use TLM 103, AKG d880 and POD straight to 1&2 without problems. So maybe you have a level misconfiguration somewhere...
__________________
- e.l - ps: btw...sorry for my english. ;-) |
#10
|
|||
|
|||
Re: AKG C3000/Digi-001 problems
I can really hear the noise cleary on either pair of my sony mdr-7506's. but only a little on the hafler m5's
__________________
Docta'J Download free music at http://www.nukmusic.com nEVER uNDERESTIMATE kNOWLEDGE |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What do people think of the AKG C3000? | Ruben_B | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 11 | 04-19-2005 07:07 AM |
Rode NT5 or AKG C3000 and SM 81? | TrippSTRAT | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 13 | 02-12-2003 12:21 AM |
DIGI preamps & AKG C3000 | nukmusic | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 6 | 05-10-2002 11:10 AM |
PC Probe problems. Any overheatingg problems with Digi 001 | Ajay | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 4 | 03-03-2002 05:30 PM |
AKG-C3000 | sammi10000 | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 13 | 08-06-2001 08:59 AM |