Elastic...adding Warp markers

[mstucker]

Anyone know if there is a way to select a section of audio and place warp markers over all of the event markers? It only seems possible to add each one individually.

Thanks,

[Vaporhead]

Open the quantize window, set the sensitivity to 1 and quantize. You will then have all of the warp markers but they will not have moved any audio because of the low sensitivity setting.

[mstucker]

Thanks Vaporhead, I can't wait to try it.

[Steve MacMillan]

Open the quantize window, set the sensitivity to 1 and quantize. You will then have all of the warp markers but they will not have moved any audio because of the low sensitivity setting.

Sometimes you have to set it to 2, 1 doesn't always work.

[zakco]

This may be obvious, but just in case I'll mention it...you won't see the sensitivity adjustment parameter in the quantize window until you select a groove template. It took me a while to figure that out. But then again, I can't find anything in the fridge either...

[JimWest]

FYI, a fix in PT 7.4cs2 (and subsequent releases like cs3) may be relevant to your workflow:

Fixed: Elastic Time Warp Markers Could Move After Quantizing (Item #100423)
* Quantizing a selected area could cause markers outside that selection to move

http://www.digidesign.com/index.cfm?...4&itemid=29792

Jim West
Digi