My Parametric Eq Settings changed

[bredo]

???

The settings on the parametric eq have changed across all patches. The Q-value of the 3 upper bands + the Eq type on the lowest band (HP filter type reset to HP24 and Q= 0.7).

Anyone else had this?

PS. This is for presets/patches I have used for a long time.

Anybody has a clue?

[Benoni]

Are you seeing this in the Editor or on the Rack itself?

I mentioned something like this awhile back in a video. Is this the same issue you are talking about?
https://www.youtube.com/watch?v=u0LUa9C_zb4

[bredo]

Thank you very much Sir.

This was it for the Q values. But...

... But one other thing I noticed was the change/reset of the HP filter slope.

For patches I know I have used HP6, it reset to HP24...... With the end result of removing much/all low end (due to the steeper filter).

Some other patches I could hear a difference, resulting in a "duller" sound.

Thanks again. I will check some more.

[Benoni]

Originally Posted by bredo

Thank you very much Sir.

This was it for the Q values. But...

... But one other thing I noticed was the change/reset of the HP filter slope.

For patches I know I have used HP6, it reset to HP24...... With the end result of removing much/all low end (due to the steeper filter).

Some other patches I could hear a difference, resulting in a "duller" sound.

Thanks again. I will check some more.

The changing of the filter types is something I have not seen. Is it every patch? Do you notice any similarities between those patches... like, do they all use a certain amp, or effect, or something?

[bredo]

I have narrowed it down to: When I load some of my own Eq presets (that I know I had the HP6 setting) they open up with the HP24 filter. Hmmm, strange.

No big deal though, as I just can change the filter type.

PS. I may have to re-save my presets after the change. I will try that, and see what happens.

Thanks again.