synced with pro tools- see signal, but can't hear signal- HELP!!!!

[hitwriter]

I have synced to pro tools, and have made the mpc the master, oo1 slave. I also have the audio of the mpc going to tracks 3/4 of 001. When record enabled I see the signal on tracks 3and 4 but hear nothing, as well as no audio waveform shows on the screen, but I see the SIGNAL! What is the problem?

[Bastiaan]

maybe you actually have to start recording

1. set up a channel to record to (audio-channel, not aux-channel...)
2. route an input to that channel
3. record enable the channel (little "rec" rectange above the fader.)
4. hit the record-button in the transport-section
5. hit the play-button in the transport-section

(or skip step 4+5 and press 3 on the numerical keyboard with num-lock switched on...)

now you are recording....

To listen to what you do, you ether have to connect a headphone to the digi001, or connect your amplifier or powered monitors to the "monitor out" on the back of the break-out box. The monitor-button on the front of the box should be depressed!

All this is perfectly written down in the getting started guide...