Change Anchor Position

[Daryl Hughes]

Is it possible to change the anchor position of an audio file/region within the edit window? I found this a handy feature when using Logic a while back. It meant you could choose the opposite side (right) of the audio region so it would snap that side to the grid opposed to the common Left side. I found this handy when working with reversed audio such as sweep effects and reverse cymbals.

[boomsounddesign]

You can use command + comma to set a new anchor point. Then you can spot the clip by using control + shift.

[Daryl Hughes]

Cheers

That's not quite working. All I want to do is enable the right side of the region to snap to the grid. These regions are effects so they only happen at the end of every 16 bars and do not follow onto another region. If so I would of used "shuffle" so it would sit perfectly before the beginning of the next 16 bars.

[boomsounddesign]

Try using relative grid. That should let you do that.