Pro tools 9.0.2 and osx 10.6.7

[gives]

Originally Posted by AloVicious

Hello All...I'm fairly new to Pro Tools...and, apparently I've screwed myself, lol

I have Pro Tools 9.0.2 and use a Digi 003...all was working fine until recently...and the only thing that has changed is updated my mac osx from 10.6.6 to 10.6.7...now...Pro Tools will crash unexpectedly in frequent randomness, and I get no audio from my Pro Tools sessions...all the I/O settings look correct...but still no audio...I know the 003 is still working properly, because I can listen to Pandora and utilize my 003 and monitors...I read the previous post and repaired my permissions following the update...but, still no luck The only thing I didn't do, was run the "combo"...I just ran the update from the automated update installer...and then things started to act funky in Pro Tools...I'm currently downloading the combo updater from Apple's site and I'll go to disk utility and repair permissions following the update...any suggestions anyone may have will be greatly appreciated!!

Thx
--Ace

The operative word or phrase is, "fairly new to Pro Tools". You probably will have a lot of these.. I know I did at the start. Have an HD session, but am guessing this may be a firmware issue..maybe, but not sure. There are probably a few more variables with you system you will have to get familiar with. G

[AloVicious]

Thanks for the help, fellas...I think it might actually be a plug in on a certain session I was trying to open...I can open other PT sessions and they are running fine; no crashes and I get audio...it seems to be narrowed down to this particular session...I think the plug in question is Xpand!

[Digitopian]

Thanks everyone, sounds like good news. I did the update.... no issues. It still scares the crap out of me doing even basic updates if they are not "officially supported". Thanks for the feedback!

[CME]

Originally Posted by Digitopian

Thanks everyone, sounds like good news. I did the update.... no issues. It still scares the crap out of me doing even basic updates if they are not "officially supported". Thanks for the feedback!

That's why cloning your system drive before installing an OS update is so useful.


Sent from my iPhone using Tapatalk

[DonM]

Another 10.6.7 and PT 9.0.2 running well (so far!)

2011 MBP 13" 4GB Ram 7200 RPM drive

-D

[dnadig]

Originally Posted by PMoshay

Did this happen after the update to 10.6.7?

Yes, The update I installed is a special update for this Sandy Bridge quad MacBook Pro. I could go back to my 10.6.6 clone, but 10.6.7 fixes other things on this computer.

[sorce]

Im in a [bleep][bleep][bleep][bleep] storm
I can't use my MBOX pro 2 at all. I just get -6085 errors.
repairing permissions now seeing if it works after that

[SessionKat]

-6085 = something is interfering/clogging the FW port streams.

Did repair permissions help?

-tv

[BigEvil]

Why risk it? You're just adding one extra factor into the already unstable mix and will make it even harder for digi and users on here to properly troubleshoot you.

[gclef101]

Has anybody had any trouble installing the update? I keep getting an error message saying this image file cannot be mounted. I re-downloaded the dmg file and tried to open it again and I still get the same error message.