automation on a bus

[MidnightFlyer]

I have reverb on a vox track that was bussed to an aux. When I try to change the reverb on the vox track via the fader, the fader keeps going to a set position. I have inadvertently written reverb automation. Now I know I can void the automation by switching to 'auto off', rather than 'auto read'. But out of curiosity, how would I go about deleting the automation from the bus entirely?

[Anthemmusic]

I have reverb on a vox track that was bussed to an aux. When I try to change the reverb on the vox track via the fader, the fader keeps going to a set position. I have inadvertently written reverb automation. Now I know I can void the automation by switching to 'auto off', rather than 'auto read'. But out of curiosity, how would I go about deleting the automation from the bus entirely?

On the selections available for that track in the edit window- where you select waveform, volume, pan, etc., - there will be a selection for "send 1/2" or whatever. This will show the automation that has been written, just like on a volume automation.

I like being able to adjust e.q. like this by auto enabling the parameter you want to use in the plug-in. Works good on say, a high pass filter if an instrument needs to be thinner in a certain part of a song. It's easier to adjust in the edit window, then doing the "auto write", "auto read", etc. thing.

Hope this helps you out.......

[MidnightFlyer]

Yes, that did it. thanks. I'd never seen that before.