Assigning faders to VCA masters in Standalone software?

[InjuredEar]

I'm trying to build a show here and I've run into a bit of a wall. I can't figure out how to assign faders to VCAs. Am I missing a little button or a right click somewhere?


I'm running D-Show Standalone software on Win XP inside VirtualBox on my Macbook.

Thanks,

Greg

[mariojorgeandrade]

Hi, Greg.
It's easy at the stand alone too.
While in the Outputs tab, choose a VCA, click on the assign switch (right side of the screen, just below the "members" area), go to the Inputs tab and select the channels you want.
I do it that way, maybe there's an even easier one.
I also run the Stand alone software on a Mac, inside a Parallels Desktop Win XP virtual machine.
Good luck.
Regards,
Mario Jorge Andrade
Brazil

[Kenmillerjr]

Adding to what Mario said...

Do exactly what he said, but do not forget to go back to the outputs page to finalize the assignment by clicking the assign switch again. That could potentially be a big mistake come showtime.

[dstagl]

I would just wait until you're in front of a console. It takes 30 seconds to assign VCA's using the console, and if you've got everything else ready it's an easy last step.

Dave