DigiTest failure?

[UCB_Theater]

Hi,

I have just rebuilt a "legacy" ProTools 6.4.1 (mac G4) 888 I/O (2) DI24 + (2) farm cards and ProControl surface. I have it up and running but I do get a couple failures with Digitest. The di24 passes, but the 1st farm card shows TDM Transmission test failures on DSP A, B, C and D, everything else passes. The 2nd farm card shows failure on TDM Transmission DSP A, everything else passes.

Should I be concerned about this? Things seem to be working as far as I can tell (the 'Meant to Be' demo is working). Is this just something not connected?

Thank You for any insight or assistance. I am a total beginner with ProTools.

Sincerely,
eugp

[jeffro]

It's likely a hardware failure. Can you test 1 DSP Farm at a time (with the d24) to try to isolate the problem?

[Keith Hernandez]

Yo, I am at UC berkeley too and can help if needed. I too have a legacy setup.