Outputs in the wrong place...

[RJW1982]

Hi there.

I have a protools HD system with a strange issue.

My outputs are coming up on the wrong channels. It's HD3 hooked up to two 192's, and for some reason the outputs don't appear on 1&2 (1 Left, 2 Right) they come up on 6 & 7! - AND they are reversed, so 7 is the left channel, and 6 is the right channel.

I've worked round it by changing my outputs to 6 & 7 in the I/O setup (and swapping the left/right over), but it's not ideal!

Any ideas how I can get the left & right back on to channels 1 & 2 where they should be? Maybe I've hooked something up wrong, but what do I check?

Big thanks to anyone who has an idea about this and can spare a few mins to reply!

[DigiTechSupt]

What are the outputs of your 192's connected to? What types of cables are you using (DSUB on 192 side to...)?

Does your IO Setup look something like this - with a 192 rather than a 96?


IO Setup Window

[RJW1982]

Hi, I've figured it out now... I was just Loop syncing the two 192's before, I've now introduced a SYNC I/O into the setup and the outputs are in the right place now!

Thanks for replying anyway!

[RJW1982]

GRR! Well yesterday I introduced a SYNC I/O into the setup, made that the loop master and everything was fine - outputs in the right place.

Come back today though and its back as it was before, channel 7 is left and 6 is right... WTF!

I've been chasing my tail all day on this one, anyone got any ideas?