Blue Screen 10.3.5

[Shatzer]

Just installed the update. Once it told me to reboot immediately got the BSOD. Uninstalled and went back to 10.2 as I was having problems before with 10.3.4. Not really looking for specific advice, just thought I'd share to see if anyone else experienced this. Never had any problems with Pro Tools until these last few updates.

[sunburst79]

Knowing the specific BSOD message would help diagnose the problem. It may or may not be specific to Pro Tools.

I always like to run Memtest+ when ever I see a BSOD if just to eliminate bad memory.

I've seen BSOD errors once and a while after updating drivers, adding memory etc. Usually a reboot takes care of things and the error never returns. This is not common behavior and not something I would be overly concerned about. If however a certain program causes a BSOD on a consistent basis then some troubleshooting is in order. I'm not aware of anything in any of the 10.3.x updates causing a BSOD.