Euphonix MC Control V2 - Control room knob PT9HD-HELP

[hugoleitao]

hi all

I know this probably has been discussed here a lot of times, but i still cannot figure out a way to get the control room knob working.
I have a simple system, 192 I/O HD1 with pro tools 9.04HD, my eucon apps are all updated running the latest 2.6.2 software and the 1.3.4 firmware. I did all the basic steps, i've created a source starting channel 1 format stereo type bus.The check box on the control room section is checked, in the patching section SME out from the 192 are selected, channel 1&2 L&R.
I ve set my Digidesign HW (HD) under the config section, core audio pops up, and after this i will never get pro tools launching, which is normal because SME is using the core audio driver, when i quit digi core audio SME alerts me that the previous device is not available anymore but if i leave it open PT wont launch.What i'm doing wrong, i have to select the device i wanna control right? I just need SME controlling my source outputs.
Please, if anyone with a similar system could explain step by step how to get this working would be really appreciated.


Thanks


hugo