OT (I think): Granulab and audiomulch problems.

[Shane Cullinane]

anybody use these? granulab used to work fine on my computer but now when i try to load a (16bit, 44,100khz) audio file and play it i get a message saying-

"the specified file format is not supported or cannot be translated. Use the capabilities function to determine the supported formats".

also in the "I/O options", "under select wave output device" the digi 001 is not listed. should it be?

in audiomulch i get a similar message to the one above but it also says "the following error was encountered while activating an audio device: Unanticipated host error (Portaudio error -9999)."

the last time i used granulab was before i upgraded to PT6. I havent ran audiomulch at all on this pc. Any suggestions?
thanks.

shane.