Can't see surround panner

[Kroger]

Just made a surround session with prober surround outputs (made a 5.0 output in i/o)
I also get sound out, but for some reason there is no surround pan at all on the tracks.

Any idea of what I have done wrong?

[bad jitter]

Have you assigned your tracks' outputs to that 5.0 output?

[Kroger]

Yep.
I used the 5.1 SMPTE i/o template from digi. checked in the i/o window that it's assigned correctly to the outputs.
I then used the 5.0 output from that on the track i have (an aux with the signal generator on). Also used the actual 5.1 output with no difference.

Everything is fine with the sound. I have output on all the speakers and the channels are correctly assigned. The issue is that I have no panning on the track at all. It just sends to all the channels.
When looking in the documentation it says that the surround panner should "pop up" when the track is assigned to a valid surround output.
I also have the surround mixer plugin installed.

I have uploaded a test session here: www.kroeger.dk/surrounddigi.ptf

[bad jitter]

Can't open your session now but... If you have 5.1 track in 5.1 session then yes, you have no panners. However, your mono and stereo tracks going to 5.1 output or 5.1 bus should have panners automatically.

[Kroger]

DOH!!!!
Sometimes the obvious just won't come to me.....
It was of course because I only tested it with surround tracks.

Thank you for telling me the obvious

(I never use surround, so even the most basic mistakes can trick me)