|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
|||
|
|||
Samplecell not recognized - help!
New g4 450MP with factory specs (128MB Ram, 30GB, etc)
Samplecell is only card in there and passes tests with digitest 3.3. Samplecell software is 2.1.1 and SC init is 2.0.4. Both were the latest I could find on the website. OMS 2.3.8 is installed with and works with MOTU Express XT USB and all attached devices. Cannot get OMS to recognize Samplecell card and therefore cannot launch Samplecell editor because I think it looks at the OMS setup first. Any suggestions would be greatly appreciated. Thanks in advance. |
#2
|
|||
|
|||
Re: Samplecell not recognized - help!
Hi,
Start with trashing the samplecell init in the extensions. Any Digi init later than 4 has the latest init for samplecell built in and will conflict if both are installed and will give you this problem. So go with only the Digi init and it will work. Good Luck!!! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Samplecell and Rex | Charles Deenen | Digidesign Hardware & Software | 1 | 09-15-2002 01:25 PM |
Samplecell | davidcruz | Digidesign Hardware & Software | 1 | 06-23-2002 05:30 PM |
Soft SampleCell not compatible with SampleCell 2 | P BUCKLE | Digidesign Hardware & Software | 13 | 06-08-2001 11:01 AM |
Soft SampleCell not compatible with SampleCell 2 | P BUCKLE | Pro Tools TDM Systems (Mac) | 11 | 06-06-2001 10:24 AM |
SampleCell II PC spec & access to samplecell CDs | Dewi | Digidesign Hardware & Software | 0 | 10-24-1999 10:32 AM |