Loop master wierdness

[parak]

Hello. This problem showed up after 2 months of working OK:

SYNC I/O (firmware 1.02)
4 192's
Nanosync
PT 5.3.1
OS 9.2.2
Dual 1ghz

In session setup window I assign "Sync" as clock source. When I click off the menu, it reads "Internal" instead of "Sync". If I click on the menu again "Sync" has a check next to it, but so does "Internal" in the sub-menu for 192 #1.

Also, both the 192 interface and the SYNC I/O have their Loop Master led lit.

Trashed prefs, re-installed PT, re-upgraded the SYNC I/O firmware, swapped cables, waved a dead chicken over my head while dancing on one leg, nothing. Funny part isthe system seems to work ok, but this just doesn't feel right. Any suggestions?

Thanks, Keith

[Groink]

Hello. This problem showed up after 2 months of working OK:

SYNC I/O (firmware 1.02)
4 192's
Nanosync
PT 5.3.1
OS 9.2.2
Dual 1ghz

In session setup window I assign "Sync" as clock source. When I click off the menu, it reads "Internal" instead of "Sync". If I click on the menu again "Sync" has a check next to it, but so does "Internal" in the sub-menu for 192 #1.

Also, both the 192 interface and the SYNC I/O have their Loop Master led lit.

Trashed prefs, re-installed PT, re-upgraded the SYNC I/O firmware, swapped cables, waved a dead chicken over my head while dancing on one leg, nothing. Funny part isthe system seems to work ok, but this just doesn't feel right. Any suggestions?

Thanks, Keith

I've got nearly the same config and the exact same problem and done the same amount of troubleshooting. Only thing it is causing me to lose sync while chasing TC from a Digi Beta deck, which IS a huge problem. Anyone got an answer?