SLAVED "UNIT" IS STOPPING WHEN SYNC TO MTC

[VULCAN]

WHEN SYNCING TO LOGIC SILVER OR TO MY ROLAND 1880 USING PRO TOOLS AS THE MASTER (MTC TO PORT)THE SLAVED UNIT IS STOPPING AFTER A FEW MINUTES OR EVEN A FEW SECONDS.PRO TOOLS CONTIUES PLAYING BUT THE SLAVE STOPS.I HAVE TO RELAUNCH PRO TOOLS TO GET THE SYNC BACK ONLY TO HAVE IT STOP AGAIN.I AM RUNNING PRO TOOLS LE 6.0 ON A G4 DUAL 1.25 (NICE!)I HAVE RUN DIDITEST (SYSTEM OK) AND HAVE TRIED DIFFERENT MIDI CABLES.PLEASE HELP ME.

ALSO MY MAC IS OSX 10.2.3
THANKS

[damir]

upgrade to version 6.0.1 and hope for the best.i have found a number of midi faults with v6 and some of them have been fixed by the new version .
as i try to use midi on protools i seem to have the nack of always finding something wrong with it and all i,m trying to do is what my dedicated Yamaha qy700 did very well except it didnt have a large computer screen and a mouse, but it did have reliability which sometimes is better.
good luck! but i,m still waiting for the next version before i go to protools midi and i hope i don,t die of old age waiting,thanks Damir age 43

[VULCAN]

Thanks Damir.I think a may wait to try 6.0.1 as I have read other posts(since I made this one)about the issue and other users are having more trouble midi wise than they did before the upgrade.I calle tech support and they advised me to try another midi interface such as the Midisport 2x2 but i have not tried it yet ($)has anyone had any luck keeping MTC communications using a different interface?

[ptuser77]

Which midi interface are you using?

[VULCAN]

I just installed the MIDI SPORT MIDI MAN 2x2 USB on my G4 and it works! I am now getting STEADY MTC to all my out board MIDI GEAR.tHIS STILL DOESN'T FIX MY DIGGI001 MIDI OUT PROBLEM BUT I CAN GET THE JOB DONE!

[VULCAN]

ptuser 77 I am using a DGI001.