Carbon Pre Settings Keep Resetting ?!

[tetonica]

Is there a way to preserve the I/O settings on Carbon Pre? My main Carbon interface is fine but my Carbon Pre (x2) interfaces keep resetting every time Pro Tools boots up.

When the 2023.12 Pro Tools version came out my Carbon Pre (x2) started resetting their settings (all inputs change from line to mic). I was hoping that with 2024.3 the issue will go away but is still happening... not sure if there's a firmware upgrade available (don't see the option in Carbon Central)

Any help or tips would be greatly appreciated

[jeam25]

Hi you can try a firmware reset.

https://avidtech.my.salesforce-sites...roubleshooting

[tetonica]

Originally Posted by jeam25

Hi you can try a firmware reset.
https://avidtech.my.salesforce-sites...roubleshooting

Thanks -- I've just tried the firmware reset but no luck. Both Carbon Pre (x2) have all their inputs reset from line to mic inputs.

Successfully did the firmware reset to both Carbon Pre (x2) and to the main Carbon interface and then upgraded the firmware to all units.

But even with the Pro Tools Setup-->Hardware settings selected option to "Retain Mic Pre Settings" still all settings get reset from Line to Mic when loading Pro Tools

[MCorbin]

Hey Tetonica

We've reproduced this in house. I'll see if someone in Support can reach out to you and set up a case so we can get this to Engineering to fix.

Nice catch!

mark

[tetonica]

Originally Posted by MCorbin

Hey Tetonica

We've reproduced this in house. I'll see if someone in Support can reach out to you and set up a case so we can get this to Engineering to fix.

Nice catch!

mark

Excellent - thank you!! I'll be around if support reaches out

Hope it's an easy fix

[tope d]

Hi!

I've started a support case under 04774372. Team will reach out via Email.

Thanks!