PT6 error 7100

[AINSLIE]

error 7100. Causes me to rester the computer for session to function correctly again.
This one is driving me nuts. Answerbase offers no solution to fix other than restart. It admits hardware is OK.

I have an HD4, OSX 10.2.4, Magma 7 slot, 1GB Ram on a Dual 1GHZ.

This does not occur with the same sessions on OS9. Same hardware. I suspect there is a known issue here by Digi.

Ideas anyone?

Ainslie
(trying to stay in OSX but struggling!)

[DRudin]

ainslie, I am running HD3, OS 10.2.4 on a G4 933. I have NOT had this error (yet) and notice that you are running a Magma chassis... any chance this is the problem spot?
I ran a Magma chassis for 3 years... never a problem, but I was just wondering.
Oh, any ideas why I'm having -6042 errors in PT 6.0? I haven't seen these suckers for a long time and did not miss them!!
Dan

[toddro]

HD2/dual 867/PT6.0/10.2.3

I've had a few -7100 errors as well. If I quit ProTools and re-lauch and the re-open session it will fix them 100% of the time so far. I do not have to re-start the computer. No Magma chassis here, but same problem...

It has not been a huge problem, but would be nice to fix.

Todd R
Nashville

[DigiTechSupt]

Hello,

What are you doing when the error comes up?
Playing back a session, inserting plug-ins, creating tracks , etc?

Mike

[AINSLIE]

Support - thnx for the reply ..

This error occurs when I open a big session after closing a big session. Usually the DSP chips are all full, or near full in both sessions

Thnx, ainslie

[DigiTechSupt]

What third party plug-ins do you use and have active in the sessions? Do the session open at all? Are you able to manually assign voices to the tracks after the session is open?

Mike