C20 cap track in control 24 damaged.

[ajazzie]

Found my problem, well more than likely.
The C20 cap on the board has a damaged negative side( fitting ring) on the circuit board.

This undoubtedly is my cause, does anyone know where the negative side of the c20 cap terminates or tracks too on the power supply circuit board? I’ll need to jump the negative side to the same place if possible, realising it’s a multi layer board this is difficult but not impossible.


One Possiblyis it may be the same as the C19 cap track, however without any schematic it’s extremely difficult.

Does anyone have a schematic for this, I know it’s been asked a zillion times.

Even an excerpt for this area would be fantastic.

Regards.

[tope d]

Hi, you can try and check with some of the authorized repair centers. https://avidtech.my.salesforce-sites...roduct-Repairs