ProControl PT9 Faders not displaying ch3-6

[sean c]

Unless I'm going crazy, I swear ProControl used to display the first 6 channels of outputs from within ProTools on the main fader displays.

Now it seems to only show what's on the first pair (generally the main mix), even if I have other submixes going out the 3-6 hardware. I'm sure this was a software feature since outputs 3-6 were never actually wired up into the ProControl, but it was a convenient way to visually check that the alternate mixes were playing the proper elements.

Can anyone verify this or has found a solution?

Thanks.

[Delta Music Belgium]

This comes from the ProControl manual (PT 6.9) (http://akarchive.digidesign.com/supp...ol%20Guide.pdf)

Configuring the Output Meters

You can specify the Output path for the ProControl Output meters by selecting a default metering path in the Pro Tools I/O Setup dialog. Default metering paths can be set for each supported mixing format.

To select a default metering path:

1 Choose Setups > I/O Setup.

2 Select the appropriate path from the Metering selector and sub-menus.

Choices include:

Out 1–8 The default setting, Out 1–8 maps your current Outputs 1–8 to ProControl Output
meters.

Output and Bus Selects any available output, or Bus, path to display in the ProControl Output meters.

3 Click OK to close the I/O Setup dialog.