attaching a USB microphone

[RobbieJ]

Hoping someone can help me out with this.
I've been loaned a USB "Yeti" microphone and I cannot figure out how to sync it up to run with PT10.
I can get it running with other programs but not with PT.

Anyone have any ideas?
Is this even possible?

Thanks

[sw rec]

Hold down N when you launch Pro Tools, and it should show up in your audio devices list. But remember, that constitutes an "interface," and it'll only see one at a time.

[ChuckS]

The problem is probably no output available if you only select the mic as the audio device. On a Mac, create an aggregate device with the USB mic and something else for output. On a PC use ASIO4ALL to do the same aggregation in the advanced configuration panel (displayed by clicking on the wrench).

[RobbieJ]

thanks for the advice...i'll give it a shot

I did get the mic to come up in output and have made and input of the mic but now I have an annoying looping effect that i need to get rid of.