How to know the 11R settings of an old recording

[FunkzzaJ]

Hi - yeah that !

Is there a way to find out how my Eleven Rack was set up, in an old recording I made? Rig?

/T

[nednednerb]

If you don't have an old session, best bet is turning knobs. If you don't have the clean recording, you ALSO have to recreate the same guitar, strings, DI, and all the other FX.

Best bet was to back up sessions.

For example... do you hear a mid high boost? Then boost the mid highs....

[FunkzzaJ]

Originally Posted by nednednerb

If you don't have an old session, best bet is turning knobs. If you don't have the clean recording, you ALSO have to recreate the same guitar, strings, DI, and all the other FX.

Best bet was to back up sessions.

For example... do you hear a mid high boost? Then boost the mid highs....

I do have an old session. Should have said that. But still I dont know how to get the settings of the 11r from there.

[nednednerb]

If the plug-ins are different versions, do you have both installed?

If you can literally physically see the old settings in the old plugs in the old session (might need to install an old version of Pro Tools too???), then you can most realistically use pencil and paper to jot down the settings.

"Recall sheets" are the old term for what was replaced by "saved plug-in settings".

[junkgear]

I'm assuming that you are talking about restoring settings to the 11 Rack hardware from an old session. This is possible if it was recorded properly. Clips that contain embedded 11 Rack settings from the rack unit should have a little 'E' icon in the upper right corner. If you select that clip and right click on it, there should be a menu entry that says 'load guitar rig settings'. Choosing that menu item will send the embedded settings back to your 11 Rack, allowing you to recreate the rig.

[FunkzzaJ]

Originally Posted by junkgear

I'm assuming that you are talking about restoring settings to the 11 Rack hardware from an old session. This is possible if it was recorded properly. Clips that contain embedded 11 Rack settings from the rack unit should have a little 'E' icon in the upper right corner. If you select that clip and right click on it, there should be a menu entry that says 'load guitar rig settings'. Choosing that menu item will send the embedded settings back to your 11 Rack, allowing you to recreate the rig.

Haha Thank YOU J-gear !!

That was exactly what I was hoping for. I successfully got it back and I even started up the 11R editor to check it up.

The 11R editor actually works like a dream here on W10 PT2022.10. It runs under W8 compatibility settings.

..." a little E " ... Poetry from J-gear

Thx again.

/Tomas