|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
|||
|
|||
Control 24\"s Fader Motor Digi-Tech
What would I be looking at as far as getting a new motor for my faders on the Control 24? My faders are sticking, then jumping around, and just plain going haywire. It seemed to come under control when I turned it of from the switch on the back, then back on after a few minutes. However, my happiness was very short lived. What's the problem and where can I get it fixed in Houston Texas?
__________________
Chill |
#2
|
|||
|
|||
Re: Control 24\"s Fader Motor Digi-Tech
Control24's need to go back to Digi for repairs, AFAIK. I'd contact them about that right away. Have you done a hard-reset?
|
#3
|
|||
|
|||
Re: Control 24\"s Fader Motor Digi-Tech
Doesn't each fader have it's own motor? You can buy individual replacement Control 24 faders here:
Digistore: Control 24 Replacement Fader
__________________
Larry Cellar Dweller Productions PT 2020.3.0 HDX, HD IO 16x16 analog, 192 I/O, Control|24 Mac Pro 2019 16-core, 96GB RAM, OS 10.15.2 |
#4
|
|||
|
|||
Re: Control 24\"s Fader Motor Digi-Tech
If it's a lot (or all) of your faders and it came on suddenly, it's probably not a motor. It's probably the fader control board. Does this Control|24 have the updated power supply? I can't remember the serial designation but if your power supply has a fuse holder next to the IEC connector then it's the old style. The fader control boards are replaced along with the power supply. If you're not sure, you might just call customer service and check with them. It was a free replacement, but a pain in the rear end to install.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Digi Tech Support: Control|24 Clicking Noise on Power On | Krumbz | ICON & C|24 | 14 | 05-19-2012 11:41 AM |
Motor Fader Firmware gone | diegogat | ICON & C|24 | 1 | 09-16-2008 10:26 AM |
DIGI TECH - READ THIS PLEASE - 002 Fader Support | IntelDoc | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 9 | 07-18-2006 10:14 PM |
Multiple Motor Mix problem (Tech Support) | Chronos | Pro Tools TDM Systems (Mac) | 5 | 12-04-2001 06:22 AM |
tech suppt pleeze-motor mix trouble | thumbolt68 | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) | 1 | 06-27-2000 05:03 PM |