WTF is Vegas Mode ??

[Bob Legs]

WTF is Vegas Mode ??

[Quig]

From the manual:

Vegas Mode
Vegas mode rapidly turns each switch LED,
meter segment, and 7-segment display LED on
and off in a randomized fashion. The faders are
also run in sine wave mode.
To enter Vegas mode:
1 Press UTILITY > Test > LED > Vgas (Vegas).
2 You can change the rate at which this LED up-
dating occurs by rotating either a channel en-
coder or the SCRUB/SHUTTLE wheel. Turning
an encoder or the scrub wheel to the left de-
creases this rate while turning to the right in-
creases the speed.
3 When finished, press EXIT.


In other words, it just makes everything flash and move, just to look "impressive".
Pretty useful, huh?

[Mario C]

Not just impressive to clients and small children, but to upper management, too!

[hlynur]

Vegas mode sold me the control24 heheheh

[foo-bu]

vegas looks so much cooler on a D-Control

its not just for looks. its practical application is that it tests all the LEDs to make sure that they're working

[Kroger]

Yeah, because in Vegas mode you will for sure discover if a LED is gone

I definetly think that the tests where allt the LED's is all lid is a better way to check....

Besides that theVegas mode is always a fun act