Output to Amp 1 (front), no sound? PT LE8

[Johnster]

I apologize if my previous comment was not relevant enough, but this was the most relevant thread that I was able to find.

I'm not sure if the problem (described in my previous comment) is due to a defect in my Eleven Rack, or if there is a control that I am not aware of.

Any help that anyone here can offer would be greatly appreciated.

[aaron.ferrer]

Originally Posted by Johnster

I apologize if my previous comment was not relevant enough, but this was the most relevant thread that I was able to find.

I'm not sure if the problem (described in my previous comment) is due to a defect in my Eleven Rack, or if there is a control that I am not aware of.

Any help that anyone here can offer would be greatly appreciated.

check your rig output settings. with the weak channel, are any effects applied? As in, is that weak sound present when you use delay or chorus or anything?

[Johnster]

When going to the "Output" part of the rig, the rig volume to Amp 1 and to Amp 2 are each set at 5.0 db. The weak sound is present whether I have Chorus on or Bypassed. I wasn't using Delay.

[aaron.ferrer]

Originally Posted by Johnster

When going to the "Output" part of the rig, the rig volume to Amp 1 and to Amp 2 are each set at 5.0 db. The weak sound is present whether I have Chorus on or Bypassed. I wasn't using Delay.

Rig output SETTINGS. NOT volume.

Hold EDIT>Rig Output.

This is which point in the signal chain is being routed to the output.

[Johnster]

Thanks a million, Aaron! That did it. The "Left" and the "Right" were on different settings for some reason, and I put them both on "Rig Output".