"Bus error" in thread "MainThread", at address 0x0

[mnicoli]

Hi there,
I installed PT9 drivers for my MBox2 mini from the drivers disk in the package,
then installed the software from the software installation disk in the package,
then I authorized and transfered the license onto my ILok from my account,
but when I launch PT9 this message come up:
"Bus error" in thread "MainThread", at address 0x0
Anyone knows what is this about?
Thanks

[julopoto]

Hello, I just got this bug and fixed it, after reqding qbout the subject here I could not find any solution so I started reading the error report from apple.
It seems to have been caused by Automap, I recently intalled it with my new Novation Nocturne midi controller to use In Ableton Live and I enabled all my plug-ins in automap, so I unchecked them all and was finally able to run protools smoothly, I will do some more test to see if I can run it in Protools.

Hope this was helpfull to at least one person out there...

[julopoto]

Hello, I just got this bug and fixed it, after reqding qbout the subject here I could not find any solution so I started reading the error report from apple.
It seems to have been caused by Automap, I recently intalled it with my new Novation Nocturne midi controller to use In Ableton Live and I enabled all my plug-ins in automap, so I unchecked them all and was finally able to run protools smoothly, I will do some more test to see if I can run it in Protools.

Hope this was helpfull to at least one person out there...