Avid Pro Audio Community

Reckless Erik · #1 12-01-2009, 03:19 AM

I´m sure this has been asked before. Can´t seem to find it in the search DUC. Is it possible to load a plugin preset using only the control surface on the D-Command?

Thanks, Nick

Soundtrack · #2 12-01-2009, 04:14 AM

I'm not sure on D-Command, but on D-Control you have to press the Sel button on any encoder in Inserts view to display the parameters for the chosen plug-in on the channelstrip.

To advance through the presets for the plug-in whose parameters are currently displayed on the encoders simply press command (control) +PgDn / PgUp.

Grz,

Louis

Reckless Erik · #3 12-01-2009, 08:28 AM

Thanks Louis. I now see it is the same on the D-Command.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Load waves setup file without changing active preset	SupreGlu	General Discussion	2	11-18-2013 05:40 AM
Default plugin preset	Jakob Clemen	003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win)	3	12-17-2007 08:33 PM
Plugin preset switching	Snitz	Pro Tools TDM Systems (Mac)	4	02-16-2006 12:52 AM
The Protools Plugin Preset Co-op	tld	003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win)	3	10-27-2000 08:40 AM
The Protools Plugin Preset Co-op	tld	General Discussion	7	10-17-2000 07:43 AM