|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
|||
|
|||
Fuse card PAL problem
Hi.
I just swapped a system hard drive from a B&W G3 to a G4 400 and now I can't get color when the Aurora Fuse card is set to PAL. If I switch the output to NTSC I get color on the external monitor, but of course my pics won't play as they are all PAL. The hard drives had virtually identical system folders on them. I have re-seated the card and re-installed the Fuse drivers after discarding all previous extensions and preferences. I also tried tossing the video out (PAL) extension to see if that would reset things but to no avail. I have swapped out the video cable as well. The pics looked bad enough in color and now they are in black and white they are awful. Any ideas? What have I forgotten?
__________________
He used to cut the grass...he was a very nice boy... |
#2
|
|||
|
|||
Re: Fuse card PAL problem
I know this sounds dumb, but are you sure it's a multi standard t.v.? And is it set to PAL?
|
#3
|
|||
|
|||
Re: Fuse card PAL problem
Yes - it is a multi-standard TV - it has performed fine until the drive swap.I'm just about to check the internal settings on it...
will let you know. [img]images/icons/smile.gif[/img]
__________________
He used to cut the grass...he was a very nice boy... |
#4
|
|||
|
|||
Re: Fuse card PAL problem
OK. the TV is set on PAL - it is definitely the output of the card that is stuffed.
Hmmmm..... no word from Aurora on this yet either...
__________________
He used to cut the grass...he was a very nice boy... |
#5
|
|||
|
|||
Re: Fuse card PAL problem
Odd.
I swapped the card with the one that was in the G3 (so now the card is with its original hard drive) and all is fine. phew. [img]images/icons/mad.gif[/img]
__________________
He used to cut the grass...he was a very nice boy... |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fuse X Card | subwoof | Post - Surround - Video | 9 | 01-25-2007 01:00 PM |
Fuse card and OSX??? | pindebraende | General Discussion | 2 | 09-01-2002 03:32 PM |
ProTools/Fuse Video Card Problem | George Bellias | Pro Tools TDM Systems (Mac) | 3 | 05-12-2002 11:24 AM |
9600 Card order for PT III w. Fuse card? | ragbor | Pro Tools TDM Systems (Mac) | 2 | 02-27-2001 08:13 PM |
re: VIDEO CAPTURE, Fuse card is approved but will Igniter card work as well? | ragbor | Pro Tools TDM Systems (Mac) | 0 | 12-08-2000 11:56 AM |