Strike goes out of sync

[rotoman]

When I set up a 24 measure loop w/Strike without any fills it syncs up fine, but when I start adding fills it will begin to go out of sync after the second pass. Is there somthing I can do to correct this? I tried setting different grid values in PT but it does not help.
(I forgot to say what Strike was going out of sync with. It was a bass track(wave file).

Thanks Tony

[Wolfram K]

Hi Rotoman,

can you please post more details about your session - for example:

1) is it a wave file Strike plays along to, or another virtual instrument?

2) did you check using a click wether it's Strike out of sync, or your bass track?

3) have you consulted the Plug-in Guide, especially page 37, heading "beat sync"?

Best,

Wolfram K

[rotoman]

Thanks for the reply Wolfram

It is a wave file of a bass track that Strike begins to get out of sync with.
It stays in perfect sync in a 24 measure loop until you begin to add Strike fills then after the first pass of the 24 measure loop it slowly begins to become out of sync w/the bass track.
I will check tonight pg 37 of the manual.

Thanks again, Tony

[rotoman]

I started a new session inserted the bass track, and strike everthing is in-sync now.
Don't know why, but it works. "Great plug-in"