Tascam TM-D4000 and Digi 002 master clock issues

[drguitar]

I am buying a used, refurbished TM-D400 full with 3 adat i/o slots from a friend

I took it to my studio and hooked it up to my digi 002 and I am having clocking problems

First of all, it seems to ONLY want to clock when connected to the 2nd adat card slot, for a moment I seemed to get it to work on the first slot, but only once, it was very finnicky and never worked again

Second, the only way that clock works properly with no pops and clicks on the 2nd adat slot is when I set the clock on my PT LE system to be slave and let the TM-D4000 be the master.

The TM-D4000 will NOT allow me to recieve clock from pro tools, it HAS TO be the master

it gives me an error message (and I apologize for not having the exact error message) that says something like clock source is out of range whenever I try to select that adat slot as the clock master even though both PT and the board are set to 44.1

very strange that it will only be master, won't work any other way

I know this is an old board and there aren't likely a lot of people using it with a new LE system these days, but if anybody could help, I would appreciate it. Thank you