New MTRX Studio installation

[digiot]

I am about to replace an aging Apogee Symphony with a MTRX Studio.
Its a HDX system so I assume that set up will straight forward.

Couple questions:
After setting up IO on DADMan do I have to then manually setup IO in Protools as well, matching the DADMan setup!? Not really clear from the research I did.

Next up, I have been using an aging Hearback Headphone monitor setup. Its headunit witch get fed ADAT from the Symphony, spits out Cat6 cables to feed 4 monitor boxes in the Live room. Is there a simple solution that doesn't cost thousands of dollars, to send Dante from the MTRX Studio to a couple of headphone mixers in the live room, negating the ADAT to Ethernet box?

Thanks in advance for any input!

[creativecontrol]

Greetings,

If you want to have explicit names for long term analog and digital IO which is normalled (via DADman > Con) to Pro Tools via DigiLink - then yes, you would need to label the IO paths for what they are in Pro Tools additionally.

There are many different inexpensive Dante based headphone amp options. For small solutions - check out the Focusrite X2P or AM2. Up from there would be options like the KLANG and the HEAR Pro - which are a larger spend.

best,


Jeff