Connecting an ADAT interface to a 192I/O

[ungratefuldead]

Hi guys,

yesterday I tried for the first time to connect my Motu 8Pre to the 192I/O using and ADAT connection.

I'm able to get the signal of a Mic in to the Motu but not in PT.

The connection are fin I'm going in Hardaware tab and change the Clock source in ADAT but still nothing.

I tested the two ADAT cable and use two spare ones, also I tried the Motu trough ADAT connection on my LE system and it works perfectly.
The sample rate it's for both 44.1.

There is anything that I need to do or flag in the option in order to use it?

My system:

PT HD 2
192I/O
MAC Pro Quad core

Thanks

Matt

[BradLyons]

Did you properly route everything in the patchbay of ProTools? Which optical in did you use, the one on the digital card or the one that without the SRC capability?

[tonwurm]

maybe you tried that, but if not...

in the PT hardware setup go to tab 'digital' and set the input format to adat 1-8, then in the 'main' tab you can choose any input to adat 1/2...3/4..5/6 or 7/8


don´t forget to set the clock-source of your motu interface to follow the 192

[ungratefuldead]

Hi guys,

thanks for the reply.

I used the ADat on the Digital card and 192 I/O and Motu are sync.

One think the 192 ADAT it's supporting 44.1 or have to set it 48?

Thanks again