Avid Pro Audio Community

tenchijin2 · #1 12-20-2005, 05:40 AM

Just yesterday, I started getting an error when I bounce. The whole song bounces in realtime, then just as it's converting I get an error message that reads, in part:

"\code\azores_handel\alturaports\newfilelibs\ff\au dio\ff_audioproperty.cpp," line 33.

Can someone help me?

Thank you,

Aric

DigiTechSupt · #2 12-20-2005, 09:08 AM

What version of Pro Tools are you running?

Is it possible that, in Hardware Setups, your DAE Playback Buffer is at Level 8? If so, changing it back to Level 2 will probably help.

You might also want to try the steps in the Win XP/ Pro Tools 6.x General Troubleshooting thread.

tenchijin2 · #3 12-20-2005, 09:27 PM

I can tell you withhout even looking that the DAE Playback is set to level 8. I was unaware that would cause a problem. I put it there myself a few days back, assuming it was better based upon the description in 'getting started'.

I'll put it back and see if that fixes it.

Thanks,

aric

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bouncing problem	mwsmith007	General Discussion	4	01-06-2013 08:25 AM
bus routing problem and problem bouncing to mp3	haydini	003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win)	7	01-24-2006 10:50 AM
Problem bouncing down	WRX07	003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac)	8	12-15-2005 09:55 PM
bouncing problem - please help!!	chooseastar	003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win)	0	12-29-2003 05:46 PM
problem bouncing with 6.1	MGalway	Pro Tools TDM Systems (Mac)	10	08-22-2003 05:30 PM