Chorus vibrato problem

[warmothjoe]

Hi guys,
it's my first post here, excuse me for my bad english and feel free to correct my mistakes.

I did the same request in the elevenrackpresets forum, i try here, maybe someone has encountered the same problem.

I have a problem with the chorus/vibrato, placed after the amp and the cab, it doesn't work, i switched on and of the bypass and it's the same sound without effect. If i place the chorus/vibrato before the amp it works great. I also did a reset and a update of the firmware 1.0.3

Thank you i advance

[therealmf]

I used to have the same impression, but it's not true. I suppose You're using the To Amp Out, not the two Main Outs, right? If so then it is just the Stereo/mono setting that causes the Chorus to "disappear" when placed after the amp. Set the signal routing to mono and you'll be able to hear the Chorus.

[warmothjoe]

Hello therealmf,

thank you for your reply, that was the problem, i have routing the signal in mono and it works.

Thank you

[TheChimp]

Right, we modeled this after a particular Chorus pedal which has stereo outputs, dry on one side and wet on the other...so if you pick the wrong output to Amp, you'll hear the dry signal.

Glad it's sorted out!

[Benoni]

Hey the chimp is back havent seen you posting lately. Probably busy adding a Bogner and Diezel to the Rack right

This forum needs more Chimp and Chris, (can i put that in the Ideascale)

[warmothjoe]

Originally Posted by TheChimp

Right, we modeled this after a particular Chorus pedal which has stereo outputs, dry on one side and wet on the other...so if you pick the wrong output to Amp, you'll hear the dry signal.

Glad it's sorted out!

Thank you for the explanations

[TheChimp]

We've definitely been busy, Benoni...

We have not forgotten our good friends in the Eleven Rack world, though...