[Jim K.]

I have been able to bounce to disk with no problems untill a couple days ago when I got the above error message. Here is the entire message:

Bounce Handler cannot keep up. Try
"Convert after bounce" (-9133)

I am doing 'convert during bounce' because of another problem that started a little earlier than this latest problem. I used to do 'convert after bounce' but now when I do, at the end of the bounce when it is starting to convert, I get another error message which is:

"Could not complete 'Bounce to Disk...'
command because: Access violation occured."

So even though I used to be able to bounce all I wanted to either converting before or after, now I can't do either.

This is running on a WinXP Home SP1 and I use a Digi001 box. I only have one drive, with a system/application partition, and a separate data partition where the session and bounced files reside. I've tried bouncing to either partition with the same results. Again I've had no problems for a long time untill just recently so I know the PC hardware and config are OK.

What can I do to fix either of these problems?